• Simple, precise and economical water quality monitoring

Water/Wastewater

Simple, precise and economical water quality monitoring

Mar 28 2023

The 900 Series multi-parameter water quality monitor/controller from Myron L® Company does the work of seven separate instruments and is simple to operate and install. Users can easily monitor and control several vital water/wastewater parameters with the same level of precision that Myron L are renowned for. A user-friendly LCD touchscreen graphical user interface and pluggable terminal blocks make installation and configuration a quick and simple job.

Operators can get a full, real-time picture of water quality thanks to continuous readings from up to seven different inputs:  pre-amplified pH/ORP, flexible 0-20/4-20 mA, RTD temperature, flow/pulse, BNC pH/ORP and tow for conductivity/resistivity/TDS/salinity; % rejection as a derived value is optionally available. Conductivity/TDS measurements can be selected from one of three pre-programmed solution modes: potassium chloride (KCl), sodium chloride (NaCl), or Myron L’s own 442 Natural Water™ Standard, or a “User” solution mode based on a known solution can be programmed to maximise precision. 

Temperature compensation is set automatically at 25°C; this can be deactivated by the operator if necessary. The 900 Series’ pH/ORP input channel operates with Myron L pre-amplified pH and ORP sensors. These sensors feature precision circuitry that enhances accuracy and allows sensor application over further distances. The device’s 0-20/4-20 mA input enables operator-defined 0 to full scale values and units of measurement for a wide array of different types of sensors. Electronic or wet calibration is a simple and fast operation.

End-users can activate control equipment and audible signals automatically and continuously report and record solution data with flexible outputs. This instrument includes up to 3 relays, 2 remote alarms, a 0-20/4-20 mA signal, a 0-5/0-10 VDC signal and a RS-485 ASCII serial signal. Relay outputs to all operator-supplied control equipment needing up to 250V each and can trigger on any input parameter. The 0-20/4-20 mA output can transmit a signal for any input parameter. 0-5/0-10 VDC can be scaled to optimise resolution and can output to a recorder, PLC, SCADA system, etc. 0-1 VDC is possible with an optional resistor. 


Digital Edition

AET 28.3 September 2024

September 2024

Business News - ENVEA announces acquisition of APAQ Group - SICK and Endress+Hauser sign strategic partnership - Efforts to curb gas flaring intensify amid environmental concerns Air Monito...

View all digital editions

Events

ECOFAIR

Oct 14 2024 Belgrade, Serbia

Gulf Coast Conference

Oct 15 2024 Galveston, TX, USA

AQUA Ukraine

Oct 15 2024 Kiev, Ukraine

POLECO 2024

Oct 15 2024 Poznan, Poland

EnergyExpo 2024

Oct 15 2024 Minsk, Belarus

View all events