E-Learning

Calibration and measurements of particulte at concentration below 5m/m3 offer signicant challenges not only to process operators and test houses but also regulators. The STA has been working with industry to highlight the areas of concern and possible solutions thes will be discussed during the presnetation.

Gravimetric PM mass is a widely used method for determining particulate concentration. Different variations of the gravimetric principle are used as references in standards and legislation. While generally accepted as an accurate method, gravimetric measurement suffers from the lack of real-time data. Dekati® eFilter™ is a new instrument which combines gravimetric PM measurement with real-time diffusion charging and current measurement. Knowledge of PM accumulation on the filter can be...

At present too much emphasis for emission control from vehicles and furnaces is placed on monitoring and cleaning the exhaust gases. This means dealing with large volumes of hot gases at low pressures. This may be unavoidable in the case of coal but the adoption of gaseous and liquid fuels allows a different approach. Gases and low boiling hydrocarbon liquids contain relatively simple sulphur compounds and may also contain mercury. This allows a fresh approach for emission control. Gases are...

Lord Whitty, President, Environmental Protection UK, will open the Air Quality and Emissions Show and Conference on Wednesday 24 May at the Telford International. Lord Whitty is the opening speaker of the Air Quality and Emissions Conference at AQE 2017 in Telford. The two day event will start on Wednesday 24 May with Lord Whitty’s presentation covering ‘Environmental Protection Legislation in the Post-Brexit Era’.

Mercury has been elevated to the status of a pollutant of global concern owing to some of its unique toxic properties which pose environmental and health risks. A chemical element, mercury is found both naturally and as an introduced contaminant in the environment, mainly from high-temperature industrial processes such as alkali and metal processing, incineration of coal and oil in electric power stations, foundries, waste combustion and oil and gas processing. Mercury rapidly moved up the...

The EPA Issued the Mats rule ( Mercury Air Toxic Standard ) February 16, 2012 for all the coal & oil fired power plants in the USA and then the EPA issued the Portland Cement Mact on Feb 12, 2013 for the cement kilns operating in the US as well. When these rules were issued the US had almost 1,350 coal & oil fired units operating and a 100+ cement kilns running as well. So the plants had to make a choice as to which technology they were going to adapt for mercury monitoring compliance unde...

Gas chromatography/mass spectrometry is a workhorse for the analysis of semivolatile organic compounds in environmental samples. The Agilent Intuvo 9000 GC represents a significant advancement in gas chromatography and provides a number of advantages for semivolatile analysis. In this presentation, the performance of the Intuvo GC is demonstrated for the analysis of semivolatiles based upon the specifications of USEPA method 8270D. Included in this study is an evaluation of the Intuvo during...

Best Practices for Environmental Sample Preparation and Testing Abstract: Environmental laboratories adhere to strict procedures to ensure that they remain certified and that their test results meet regulatory standards. During this session, Matt Groff, a veteran representative to environmental labs from GE Life Sciences, will discuss ways in which environmental sample preparation and testing can be run more efficiency and accurately, while meeting all the necessary requirements.  With o...

Emerging contaminants, such as pharmaceuticals, are a growing environmental concern.  These contaminants have been detected in environmental waters (such as surface water, ground and wastewater flows) at concentrations ranging from µg L-1 to ng L-1 level.  The majority are unregulated in the environment and as a result the risk assessment and ecotoxicological effect of the contaminants, their metabolites and/or transformation products are relatively unknown. To meet the prerequisite o...

Oxygen transfer in biological wastewater treatment represent the most energy demanding step of aerobic processes. Submerged aerators are designed to maximize the available surface for exchange by generating as fine bubbles as possible. Potential effects of process water characteristics on bubble sizes are too often not considered in wastewater treatment, while, liquid properties are known to have important effects on bubble size distribution (BSD) and transfer capabilities. The use of appropr...