New chlorine dioxide sensor
Aug 13 2018 Read 487 Times
Endress+Hauser is developing a new platform for disinfection sensors. The new Memosens CCS50D chlorine dioxide sensor supports safe and effective disinfection for clean drinking water, pathogen-free cooling water and high-quality process water
Systematic disinfection is an essential step in water treatment and legally required in many areas to protect people and systems from illness or damage. However, high doses of disinfectants such as chlorine and chlorine dioxide can be toxic, which means compliance with limit values for those disinfectants is also very important. The Memosens CCS50D chlorine dioxide sensor helps to achieve a safe and efficient disinfection by providing stable and fast measured values.
The chlorine dioxide sensor features a convex membrane made of dense, dirt-repellent material which prevents soiling and makes it extremely resistant to biofouling. Ultrasonic welding of the membrane to the sensor cap ensures its integrity, preventing dilution of the electrolyte. This guarantees long-term stable measurements and gives a plant manager the security that the disinfection process is running smoothly and the required results are achieved. High stability naturally also reduces maintenance.
Drinking water is a precious resource. That’s why minimum water loss is an important factor in drinking water preparation. Memosens CCS50D is able to deliver reliable disinfection measurements at low flow rates. In combination with the Flowfit CCA151 assembly, for example, the required flow rate is as low as 1.3 gal/h (5 l/h), which means only a minimum amount of water is consumed in the bypass and the required disposal capacities are reduced.
Many skids in the food and beverage industry use chlorine dioxide for disinfection. These skids provide only small-volume samples for dosing control. Thanks to its special membrane design, Memosens CCS50D provides a fast response time and supports precise dosing of chlorine dioxide even in these skids, leading to safe disinfection and cost savings for chemicals.
The chlorine dioxide sensor is equipped with Endress+Hauser’s proven Memosens technolog. Memosens allows for direct commissioning of new sensors without further calibration. During on-going operation, plant operators can pre-calibrate sensors in the lab, swap them into the process with plug & play, and thus continue measuring faster. Finally, contactless data transmission eliminates all measurement errors or even failures caused by humidity or corrosion.
Chlorine dioxide is more and more becoming a disinfectant of choice because its handling has become easier. Today, chlorine dioxide is available as a ready-to-use solution that does not require manual mixing or the application of chemical generators. Memosens CCS50D is the perfect sensor to support this trend. It helps plant managers comply with strict legal requirements on disinfection, whether it is in drinking water treatment, cooling systems, wash water for packed vegetables and salads, beverage production or desalination plants.
Do you like or dislike what you have read? Why not post a comment to tell others / the manufacturer and our Editor what you think. To leave comments please complete the form below. Providing the content is approved, your comment will be on screen in less than 24 hours. Leaving comments on product information and articles can assist with future editorial and article content. Post questions, thoughts or simply whether you like the content.
In This Edition Business News - Changes on the Endress + Hauser Executive Board - Nivus in full flow - Yokogawa announce appointment of President and Chairman Gas Detection - ATEX app...
View all digital editions
Feb 20 2019 Mumbai, India
Feb 20 2019 Mumbai, India
Feb 21 2019 Chennai, India
Feb 25 2019 San Diego, CA, USA
Feb 26 2019 Minsk, Belarus